Flashcards on Resin-Bonded Fixed Partial Dentures

Dental Ceramics: History, Strength & Types for Students

1 / 12

What were the early resin-bonded pontics in resin-bonded fixed partial dentures (RBFPDs)?

Extracted natural teeth or acrylic resin teeth used as pontics, bonded to the proximal and lingual surfaces of abutment teeth with composite resin.

Tap to flip · Swipe to navigate

Partial Prostheses

12 cards

Card 1

Question: What were the early resin-bonded pontics in resin-bonded fixed partial dentures (RBFPDs)?

Answer: Extracted natural teeth or acrylic resin teeth used as pontics, bonded to the proximal and lingual surfaces of abutment teeth with composite resin.

Card 2

Question: What reinforcements were used to reduce fractures in the composite resin connections retaining pontics?

Answer: Support wires, stainless steel mesh, or polyethylene fiber mesh (Ribbon).

Card 3

Question: What are the clinical limitations of the mentioned resin-bonded pontics?

Answer: Limited to small anterior spaces, restricted longevity; degradation of the composite bond to the mesh or wire leads to failure—used as provisional res

Card 4

Question: What innovation did Rochette propose in 1973 for metal retention to teeth?

Answer: Metal retention through enlarged perforations in the metal casting, allowing composite resin to extrude and provide mechanical retention after polymer

Card 5

Question: How did Howe and Denehy (1977) apply the concept of perforations in practice?

Answer: They used them in metal-ceramic pontics; they extended the framework to cover the maximum enamel surface on the lingual aspects with minimal preparati

Card 6

Question: What did Livaditis (1980) add to the concept of perforated RBFPDs?

Answer: He expanded its use for posterior tooth replacement, suggesting abutment preparation to establish a defined occlusogingival path of insertion.

Card 7

Question: What is the typical mode of failure for prostheses with perforated retainers, and what is the key point in their management?

Answer: The typical failure occurs when only one wing debonds from the tooth; the key point is the retrievability (possibility of removal and repair) of the r

Card 8

Question: Why is it dangerous not to remove a partially debonded prosthesis?

Answer: Because there is a high risk of caries developing under the debonded retainer if the prosthesis is not recemented or replaced promptly.

Card 9

Question: What should a patient with a perforated-retained prosthesis be advised to do in case of partial debonding?

Answer: Seek immediate dental care to recement or replace the prosthesis before a carious lesion forms.

Card 10

Question: According to Boyer et al. (1993), what is the estimated time to 50% failure (debonds) for the perforated design in two-wing studies over ~10 years?

Answer: Approximately 110 months.